Eggmotor paramotor related Stuff

Here are some pieces in relation to eggmotor order and powered flight in general. 1) The first part of the video shows the construction of the main frame eggmotor. This is now the third frame (use the second gig of wood particles). All joints are "stuck" and then completely "mess" with my poor soldering skills, or) 2) This section is an idea I had for the generation in-flight PMR walkie talkie, or perhaps the vehicle unit other GPS devices. By carefully selecting andShopping (blind luck really) engine Top rated / right size fan for the job then the output voltage should be used for devices requires 2 x AA / AAA sufficient. Normal is 1.5 V alkaline batteries, and all NiCd / NiMH 1.2 V are those of each. Sun devices with 2 x AA / AAA should work effectively with a minimum of 2.4 V. Test the motor / fan combo with a trip outside of the device drive revealed the following results. 22 miles hour (35kph) typical PG / PPG has 30 miles Trim speed of 1.8 hours (48kph) Typical40 hours and has accelerated 2.4V miles (64kph) on a typical flight layout. These wings are 3.0V 'no-load data available, but now I connect 2 fans might parallel or series multiple times to increase. This is still a "work-in-progress of the project. 3) At the end of the communication in flight between Sam and me, I have two computers wired headphones for a few cheap PMR walkie-talkie. 's courtesy Ugress.com (free to use for non-commercial)